3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
But steppers can also be servo driven if encoder is providing feedback. Right?
Im not expert, but afaik servo driven DC motor is more expensive and more complex to drive compared to stepper motor approch. I think we also need open source firmware that supports servo control (maybe it exists already Im not sure)
back in the day before BLtouch existed, my printer used a servo to deploy a bed probe. Marlin definitely can control a servo. (That was on a ramps board with no extra shields, too)
I think you're talking about those RC servos, no?
That's a big difference between deploying a probe and handing the dynamic deceleration required for a high speed gantry move.