34
First time in a while printing a temp tower, how am I doing?
(midwest.social)
To be clear I know it's not well lol. I just wanted the community's thoughts on what I'm doing wrong. I'm using Overture Royal Gold on a modified CR-10v2 with a real V6. Model was sliced in cura with default low quality settings.
The filament I bought a few months ago but just broke it open yesterday. It's making some small popping noises every now and again but the seal didn't appear to be broken. It seems all right otherwise, if a little sticky on the roll. I had to move it out of my filament dryer to keep it from opening the lid because it was binding so much. That's what happened to the last tower, that failed mid print. Looks nice at least.
It's managed to get beyond 200C this time! But it did fail at 190°, though that's the low end of the temp range anyway.
Back looks... Okay. I'm assuming that's the Z-seam on the inside of the arch. Bridging looks best on 220°, and I don't know what the deal with that line in the middle of 215° is, best guess is under extrusion by way of friction but idk. It broke apart right where it thins out between 205° and 200° too, so that might be my lower bound.