Thank you, I will give that a try.
Thanks, maybe it was just tangled filament ๐ค, but I will do a cold pull anyways.
I was printing PLA, it looks ok up to a certain height (although it was warping slightly), but then it becomes ugly. I will do a test print of the same height, butaybe you already have an idea.
Depends on the PKM tool I would say. I used Joplin with its internal sync with Nextcloud without problems in the past. Then I switched to Logseq which does not have an integrated sync so I had to rely on the respective clients. On Windows and Linux this works fine with Nextcloud, but automatic sync on phones (at least Android) sucks. So I switched to Syncthing for this purpose as the phone sync is more reliable now. I have however a small "server" (RPi or similar is sufficient) running 24/7 to keep the notes in sync even if my devices would not be online in parallel.
As it is in operation for 12 h per day it is obviously doing more than one tour. ๐
Maybe it was just tangled filament?๐ค
White my test print from afterwards (after unspooling the last two meters from my first self rolled spool ๐ ), grey a print from a few days ago.