3DPrinting

15592 readers

10 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe/ may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 1 year ago

MODERATORS

[email protected]

162

Word of warning to those with Prusa MK4 and Satin beds. There is a chance that the auto bed leveler will mess up and destroy your print surface. (lemmy.world)

submitted 8 months ago* (last edited 8 months ago) by [email protected] to c/[email protected]

57 comments fedilink hide all child comments

I've tried to report the issue to Prusa support but they keeps trying to diagnose it as user error. But at this point I'm at a loss and presume that it's either a firmware issue or a sensor issue on my unit.

Either way im very disappointed.

And before you ask, this is the opposite side

PXL_20240301_160413072

EDIT: I will note that this print sheet is ruined for my use case, since those patterns will be shown on the underside of my prints. But the print surface still works and can be used without issue... if you ignore the gouges that are being detailed into every print.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 8 points 8 months ago* (last edited 8 months ago) (1 children)

If this was during an auto level, it's my humble opinion that this is a manufacturer's defect in the machine that caused the damage. There should be proper coding to ensure that any increase in sensor pressure by (delta p) halt that machine and that there should be a pressure offset in the sensor such that a loss of signal or anomalous zero reading or lack of reading is done prior to levelling to ensure that a sensor failure has not occurred. My XL freaks out if a fan isn't spinning at the right speed, so they clearly know that a nominal operational check before the print starts is proper engineering design.

Of course you won't get anywhere. Unfortunately, a lot of 3D print failures really are user error so I suspect that's their default response and it takes them a good deal of proof to push them of that mark.

[–] [email protected] 4 points 8 months ago (1 children)

I 100% agree, however I went Prusa for their replacement parts and long term support of said parts. Rather than their quality which outside of the bed levels on uneven surfaces has been good.

[–] [email protected] 4 points 8 months ago

Oh, I didn’t mean to come off as dissing Prusa in general. I ponied up for an XL and it’s night-and-day better than any previous printer I’ve owned.