this post was submitted on 13 Jan 2024
23 points (92.6% liked)

3D Printing

4371 readers
11 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago
MODERATORS
[email protected]
23
BambuLab will enable everyone to use X1 Plus. (blog.bambulab.com)
submitted 10 months ago* (last edited 10 months ago) by [email protected] to c/[email protected]
14 comments fedilink hide all child comments
 

Awesome to see that Bambu and the X1 Plus devs are talking.

you are viewing a single comment's thread
view the rest of the comments
[โ€“] [email protected] 0 points 10 months ago (1 children)

Au contraire, your view is woefully naive. ๐Ÿค—

[โ€“] [email protected] 0 points 10 months ago (1 children)

Elaborate instead of belittling me.

In what way is my statement naive? LAN only mode allows you to fully use the camera and network connectivity from withint OrcaSlicer. You can disable the internet access from your router to make double sure.

Then there is absolutely no way that via software the printer can be put EOL. There are multiple third-party replacement parts on aliexpress. If your mainboard dies, then yes. You HAVE to go back to bambulab for that. Or atleast for now. I have hopes that further development of X1 Plus will enable the use of third-party chips / boards.

So... explain why i would be woefully naive. And stop being condescending about it buddy.

[โ€“] [email protected] 0 points 10 months ago* (last edited 10 months ago) (1 children)

If you haven't yet, I strongly suggest reading the other comments here that are also contrary to your viewpoint (not to mention 2-3 days old). That fact that it's technically naive to trust a corporation not to fuck over its consumer base is lost on you is telling, and I have other things to do than waste time holding your hand, bud. ๐Ÿค—