3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
view the rest of the comments
I have a home lab running two docker hosts, does it need to be dedicated hardware, or would this work?
If the printer runs a Marlin variation as firmware (Ender probably does), you can run octoprint on a Raspberry pi or more powerful stuff. Running in docker should be doable, you just need to route the serial-usb connection into the container running ocotoprint. Klipper user with Mainsail on a RPI4 here, no experience with a dockerized octoprint.
The most slicers have some calibration prints to tune flow/temperature etc. Do them before starting that 9 hour print job..
Octoprint just runs in docker, you need to connect the printer to a USB port.