this post was submitted on 28 Sep 2023
18 points (100.0% liked)
Coffee
8378 readers
1 users here now
☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
1ZPresso is amazing, just got the K-ultra a few months ago and it is my most consistent grinder, but hand grinding at espresso sizes is HARD. I'd run an experiment with your timemore and set it to near its finest grind and try to crank through 18-20g beans. You'll be able to do it for sure, but just make sure it's something you want to do every morning.
(Just for context, I'm a fairly fit guy used to hand grinding, but I have to get into position, hold the grinder against my leg, and lean over it to maximize torque in order to comfortably grind for espresso. I was shocked how different it was from even a fine pour over grind).
That said, if you have an electric screwdriver or a drill that can do super low RPMs, you can attach 1ZPresso grinders to those and basically make them electric/automatic.
I do 14-15 grams on 5 clicks on my grinder most days. It's a little annoying, but nothing that I can't manage. For the electric drill case, how do I attach it? Are there guides online?
Nice, sounds like you're definitely a candidate for manual espresso grinding, in which case that's what I'd go for. You'll definitely have a hard/impossible time finding anything anything as precise and consistent as 1ZPresso's esspresso-focused grinders at that price or looking at electric grinders.
Any drill/screwdriver with a 6.35mm socket (the widely standard size) can be attached to the same spot that the standard handle slides onto. That piece on the grinder is actually shaped like a standard hex bit, so it should fit just like any of the screwdriving heads would.
That's good to know. Thanks for the tip.
Of course. Honestly wish these were out when I got my espresso grinder, as a 1Z and a drill is probably better than anything under $1k when it comes to grind quality alone (perhaps not user experience, but the drill helps)