Anyone know what settings to change in Cura to help supports leave less markings on the print body?
this post was submitted on 07 Jul 2023
4 points (83.3% liked)
3D Printing
4362 readers
1 users here now
For everyhting 3D printing related.
Please be excellent to each other :)
Icon by Freepik, Banner photo by Thiago Medeiros Araujo
founded 4 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I'm not sure what orientation you're printing it at but you could try organic supports, those usually take up less surface area. Unfortunately with supports you're always going to have a rougher surface than printing without them
Also in this case it might make sense to split the model, then glue it together.