PocketKNIFE

1011 readers

1 users here now

This is the place for talking about all things pocket knives, and knife adjacent things. Folders large and small, multi-tools, sharpeners, even fixed blade knives are welcome. Reviews! Advice! Show off your Knives!

Also home of the incredibly loquacious Weird Knife Wednesday feature.

Simple Rules

Don't be an asshole.
Post any bigotry or hate speech and we'll cut you.
No gore or injury posts.
Keep politics out of here, unless it's knife related.
Brand/model/maker/etc. elitism is highly frowned upon.
Shilling your brand or product is OK provided that's not all you do and you make other contributions.
For sale and trade posts allowed, but site admins and mods are not responsible for the outcome.

founded 1 year ago

MODERATORS

[email protected]

Uneven edge while using a belt sharpener? (fedia.io)

submitted 4 weeks ago by [email protected] to c/[email protected]

11 comments fedilink hide all child comments

Hey, was wondering if anybody might have any tips for me! I've been using a Worksharp Knife & Tool Sharpener MK2, and have this weird issue where my knives are coming out sharper on one side than the other.

I know that shouldn't really make any sense, but I've got a knife right now that I have no problem shaving hairs off my arm with, but only with one side. If I flip it over, no matter what angle I approach with, I can't knock away a single hair. The bevel is also significantly wider on one side, which I also can't figure out how to correct but I'm sure is related.

I can't tell if this has anything to do with the fact that the belt rubs against the steel in different directions when sharpening each side (up and into the blade on the left side, down and away from the blade on the right), or if perhaps this might be an error in technique on my part. As far as I can tell, I'm keeping the blade in line with the guides properly and not deviating significantly.

For what it's worth, I'm working with a hawkbill blade. Meaning that I have to lower the knife as I draw it through the sharpener, to keep contact with the belt. I know this allows for a lot of room for error; I've been making an effort to ensure that I'm keeping the alignment correct the whole time, but it's wholly possible that this may be where I'm messing something up.

Any ideas if I might be doing something wrong or something I could try to get a more even edge on both sides?

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 4 weeks ago

Sharp on one side but not the other? That's likely a burr.
Burrs are sharp, until they rollover or break off.

Usually you'd get rid of it by alternating passes into the knife with lighter pressure, moving to higher grits.

Although, it might be difficult or awkward to control the direction and pressure with a power tool.
Another thing with some sharpening gizmos is not including the right grits.
Something Iike a 200 grit, then skipping to a 1000 grit can make weird results that kinda feel sharp enough at first, but with a toothier edge where the higher grit cannot really do its job except at the outermost superficial surface and not in the deeper portions left by the low grit.