3
printing speeds 0.4mm vs 0.2mm nozzle
(lemm.ee)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 02 Sep 2024
3 points (100.0% liked)
3DPrinting
15291 readers
22 users here now
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is 
Moderation policy: Light, mostly invisible
founded 1 year ago
MODERATORS
there's a swelling of the filament, about 1" tall, above the hot end.
Related - I've replaced the PTFE tube with a higher quality one and I've replaced the nozzle (it was indeed clogged).
Did you follow some guide when replacing the nozzle and bowden tube? Did you hot tighten it when putting them back?
What speed are you printing at, which you think is too slow? What's your acceleration?
No, it's pretty intuitive so I just did it.
Yep.
I was printing a speed test, the inbuilt one from Orca Slicer. Starts with a huge, slow brim, then low speed 10 layers, then slightly faster 10 layers, repeat until it fails.