view the rest of the comments
3DPrinting
3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.
The r/functionalprint community is now located at: [email protected] or [email protected]
There are CAD communities available at: [email protected] or [email protected]
Rules
-
No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
-
Be respectful, especially when disagreeing. Everyone should feel welcome here.
-
No porn (NSFW prints are acceptable but must be marked NSFW)
-
No Ads / Spamming / Guerrilla Marketing
-
Do not create links to reddit
-
If you see an issue please flag it
-
No guns
-
No injury gore posts
If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)
Moderation policy: Light, mostly invisible
Since I'm curious (and just a 0.4mm scrub) I'm assuming pet hair is enough to block the nozzle?
Not just pet hair, but pet dander. Pets in general just add a bunch of stuff to the air that likes to land on top of uncovered rolls of filament; I run a repair shop for 3D printers, and after some surveying, I've found that people with pets experience clogs much more often.
0.2mm nozzles are like 25% of the area that a 0.4 has. That means every, little, potential bit of problem can, and WILL clog the nozzle.
Additionally, the 0.2mm nozzles are so tiny, there's not likely a good way to clean them, as most needles are 0.3mm or larger.
Yeah that makes sense.
I guess I've avoided that since I printed and made a thing that wipes the filament as it goes into the printer, I suppose.