spitfire

My dryer has a PETG profile that uses 69C, I usually dry it for 10-12 hours just to be sure.

Have you dried it?

What about PCTG? Pretty much for anything that I’d need more strength than regular PETG I could go with PETG-CF or PCTG. The only thing that can force me to use ABS/ASA is the need for (more) temperature resistance.

Tailscale, because it’s a peer-to-peer VPN based on WireGuard with very little setup and Cloudflare Tunnel for external access to HA

Often there aren’t definitive answers, and drying never hurts;)

Have you tried drying it? Sometimes filament is not dried out of the box.

That’s pretty hot for PLA

I have had this for a while, I believe I have enabled experimental features on it.

The K1 series has graphite bushings on the X axis which should be self lubricating and should not be greased.

There’s always a chance your backups might get corrupted too if you let it continue like that

I’d shut it down before it corrupts even more, replace HBA when it arrives and run a scrub to see what’s the damage

Additional question: Developer beta for 18.0 seems like a dead end right? Is the 18.1 beta stable, or did it introduce some weird bugs with the addition of the „AI” to a small portion of users?