Summer I really make sure they’re in vac bags with indicating desiccant. Winter not so worried. I used to just not care but since getting an X1C with ams I’ve had a number of rolls of pla snap inside and trying to clear that out is annoying. Haven’t really had an issue sense although I have some esun pla+ that is incredibly brittle and will snap just looking at it.
dawnerd
joined 1 year ago
I loved Tidal until I hit some arbitrary cap on the number of songs you can dislike. Cancelled after their support had no answer for why theres a limit.
A lot of people went back, just as Reddit expected.
Hmm kinda like what they did before. It worked. I knew I was going to get one and the community built a spreadsheet tracking estimates dates.
No because it’s not decentralized. That’s like saying Twitter is decentralized because it’s microservices communicate over https.
It’s funny how you can build out a grid and find out it’s all off slightly. They’re doing some rounding somewhere and it gets clearer the further out from the start of a 90 degree you get
That overlay has such bad contrast it’s hard to see what’s going on. Big accessibility issue.
Really same reason all these companies making dramatic changes. Rips the bandaid off and lets them roll back to what they actually wanted while looking like they listen. Some are executed better than others. See Deltas medallion change for another example.
It’d be fun to mess around with if it wasn’t 12-18k for the setup.
More surprised you managed to post a negative review. Every time I do it fails amazons community guidelines check or get removed a few days after.
It’s a bit overblown IMO. Unless you’re going wild with multi material it’s about the same as any other printer. Sure it purges a little even if you don’t change filament between prints but it’s still such a small amount. I found myself purging a little each time with my Prusa and Enders before too.
If you’re that worried don’t get an ams for multi color printing. Get an ams to reduce waste for automatic spool runout switching.
view more: next ›
Should go after anywhere that has perpetual agreements including the ones that try to get around it by the last living clause or 100 years etc. I don’t know a good solution but I’m sure they can put limits and carve outs where needed.