bcnelson

joined 1 year ago
[–] [email protected] 5 points 3 months ago (1 children)

It does I play quite a bit of VR on Linux. The only think that does not work is the valve index audio output so I use Bluetooth earbuds

[–] [email protected] 8 points 4 months ago (1 children)

Valve has done a pretty good job. Probably because of their ownership model

[–] [email protected] 10 points 8 months ago

Most of the time it is to avoid xyproblem.info

[–] [email protected] 4 points 1 year ago (1 children)

Sorry I can't help with the proxmox stuff but it is absolutely fine to have a qcow2 image on an SSD pool. Modern SSD write endurance is so high as to be a non issue especially in the relatively tiny work loads that HA will put on it

[–] [email protected] 2 points 1 year ago (1 children)

This is huge for me as well and is what will keep me on Ubuntu Server until I have a very very good reason to leave or someone else adds it.

 

Hopefully it is useful for some one to know that when setting up sip for the yealink t33g you need to enable the "G729AB" codec. More generally jmp uses bandwidth.com for sip and you can find there supported codecs here

1
submitted 1 year ago* (last edited 1 year ago) by [email protected] to c/[email protected]
 

I'm really wanting to run the plasma 6 beta to be able to help find and fix bugs. How would also like the option to be able to switch back to 5.27 if i run into a larger issue. I ideally I would be able to switch back just from sddm. Does anyone have experience doing this? or guidance as to where I could start looking.

I use arch btw :)

[–] [email protected] 1 points 1 year ago

Sounds good to go then. I would appreciate it if you let me know how it turns out

[–] [email protected] 0 points 1 year ago (2 children)

I really like my zigbee thermostats and would recommend them not cloud at all. I have not found a tasmota or esphome compatible thermostat. You could make your our with relative ease use a simple relay board. But I don't think that it would look great

[–] [email protected] 1 points 1 year ago (2 children)

depending on your needs you can setup two uart components wand wire them up. I would think that the best way to do this would be with a custom_component here is a good starting place. I'm not sure id the esp32 has the right hardware on board as one of the uarts is send only and it does not support software uart. This sounds like a really interesting problem. Please let me know how it goes or if i can be of help

[–] [email protected] 2 points 1 year ago (1 children)

Unless I'm very mistaken you can not use the same account.