this post was submitted on 27 Dec 2024
1 points (100.0% liked)

Welcome to R/3D Printing! Come for the Benchy, stay for the Calibration!

6 readers
1 users here now

/r/3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed...

founded 1 year ago
MODERATORS
[email protected]
1
What is your opinion / experience with cheap filaments? (zerobytes.monster)
submitted 17 hours ago by [email protected] to c/[email protected]
0 comments fedilink hide all child comments
 
The original post: /r/3dprinting by /u/Redditisannoying22 on 2024-12-27 13:11:31.

When I started printing 7 years ago, I bought those no name filaments on ebay for like 10€ it was always a pain to use (but also the printers used to be not that good). After a few years I only bought quality filament from 3DJake for more than 20€ and they worked without any problem.

Now I found and bought eSun filament on Amazon for 12€ incl. shipping and there seem to be a lot of similar offerings. So far it works perfect. What is your experience with those cheap filaments? I might switch again to the cheap ones.

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here