Idk if this is my Printer or its Cura g.code issue but I've always noticed this excessive travel with any print and It starts to print then go back to the corner print again and then do the same thing for each little print this has honestly ruined a lot of prints i have made because the way it accelerates itll make the extruder belt or motor like get stuck then it skip and then be off track to the print and start printing unaligned. With this too ive also thought about how much print time over the last like 2 years ive wasted on print time But i then figured out what it was and it doesnt make any sense to me that the extra travel MAKES IT FASTER then when its turned OFF it takes almost an hour how does this make sense and ive always noticed it with almost every print as you can see in the video it prints out fine then it all of a sudden happens and then if you watch to the end itll even switch sides of ends at which it like returns too then prints a small part and then back to X location so if i keep the setting on itll take an hour less but risks ruining the print but if on then i waste an hour on what seems to be just a error because it uses the same value and weight not evil .00 of a decimal changes i just dont understand
THIS IS HAPPENS WHEH I TURN OFF COMBING
With it turned Off 3 HOURS
With it turned on 2 Hours Like how
https://reddit.com/link/1hmlj14/video/evdp50n4269e1/player
FYI I DID SPEED UP AND SLOW DOWN THE VIDEO
