Welcome to R/3D Printing! Come for the Benchy, stay for the Calibration!

6 readers

1 users here now

/r/3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed...

founded 2 years ago

MODERATORS

[email protected]

Is waving my build plate around a bad thing? (zerobytes.monster)

submitted 1 month ago by [email protected] to c/[email protected]

0 comments fedilink hide all child comments

The original post: /r/3dprinting by /u/therealsourgecko on 2024-12-12 22:46:41.

Recently, I've been printing a lot of Gridfinity bins and have been way too impatient to wait for the bed to cool down.

Since I have a ring on the edge of my build plate, I simply pick the plate up and wave it around the room like an animal 😂. This cools it down quickly, then the build comes off like butter.

Am I damaging my build plate? Should I stop doing this? Or should more attention span-deficient Gen-Z do this?

(Printer: Bambu Lab A1 Mini, Plate: Bambu Textured PEI plate)

no comments (yet)

sorted by: hot top controversial new old

there doesn't seem to be anything here