Machinist

674 readers

2 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago

MODERATORS

[email protected]

Southbend 9" motor potentially bad? help fixing or buying vfd (sh.itjust.works)

submitted 1 year ago by [email protected] to c/[email protected]

2 comments fedilink hide all child comments

Ok bois so my tractor lathe which i have been working on has el problemo. so i hooked it up with a new Belt because the old one was roached. and connected her up to 110V (yes i know 220 is optimal etc.) i did it just to see if the motor is brokey. it runs but its like its turning on and off, it spins up then stops then spins up. kinda like a dude at a drag race (revvvvvvvv pause revvvvvv). its rather odd and i think the motor is bad because on the motor it says PH-1 which is single phase and 115-220. so theoretically it should work just fine. So if the motor is in fact broken what are my options? ive read forms of people taking south bend 9" lathes and hooking up VFD's. which im not against using a VFD, but i would like to keep it as close to original if i can Thanks.

top 2 comments

sorted by: hot top controversial new old

[–] [email protected] 3 points 1 year ago

The motor will be printed with a frame number. You can match up the hp, frame number, and shaft diameter and it should work. Most old lathes came with reversible motors. Not all electric motors can be reversed.

Chances are if it's stopping and starting then you have a bad capacitor. Here's a link on how these motors work and what to look for to fix it https://woodgears.ca/motors/reversing.html

[–] [email protected] 2 points 1 year ago

You need to connect the motor right for the voltage. However those symptoms don't sound like the motor but instead something else in the drive is dragging somehow and the motor can just barely power past. I'm guessing though, you need to get the motor wired right for the voltage first which means finding and reading the nameplate.