this post was submitted on 15 Aug 2024
2 points (100.0% liked)

Home Improvement

9007 readers
1 users here now

Home Improvement

founded 1 year ago
MODERATORS
 
top 21 comments
sorted by: hot top controversial new old
[–] [email protected] 2 points 2 months ago (1 children)

If you don't know, call someone who does.

[–] [email protected] 2 points 2 months ago

This right here. If you have to ask this question before you trace a pipe back to it's source and figure it out for yourself, you should not be fucking with gas lines.

[–] [email protected] 0 points 2 months ago (2 children)

That is a gas connection. Screw the flex hose on there and put soapy water on the junction to check for leaks before you open the valve.

[–] [email protected] 0 points 2 months ago (1 children)

That's a square tip plug. It could be a gas line, but ur not getting the drier hooked up to that thing.

[–] [email protected] -2 points 2 months ago

Gas dryer, my man.

Cheaper to run than electric.

[–] [email protected] -1 points 2 months ago (1 children)

You're not going to see any leak without it being turned on.

[–] [email protected] -2 points 2 months ago* (last edited 2 months ago) (1 children)

check for leaks before you open the valve

Put the soap on first, then open valve. Are you having a reading comprehension problem or being pedantic?

[–] [email protected] 1 points 2 months ago (2 children)

Did you read what you wrote or you trying to be an asshole? You literally wrote, check for leaks BEFORE you open the valve.

[–] [email protected] 0 points 2 months ago (1 children)

You're having a reading comprehension problem.

Put the soap on to check for leaks before turning tap on.

This implies the soap is to check for leaks

[–] [email protected] 0 points 2 months ago (1 children)

All I said was you need to turn it on to see if it leaks. If you're explaining how to check for a gas leak, It's a pretty important step. By reading his comment, if OP knows nothing about it, which is clear by their asking, they could just put soap on it, see no bubbles, and then turn it on and walk away....

[–] [email protected] 0 points 2 months ago (1 children)

If op doesn't have the understanding of turning it on to see if it leaks op should hire someone to install their new dryer and return their adult card

[–] [email protected] 2 points 2 months ago

Sure, but no reason to not give all the information, especially when it comes to something as dangerous as a gas leak.

[–] [email protected] -1 points 2 months ago

Learn 2 read, poindexter.

[–] [email protected] 0 points 2 months ago (2 children)

I did not know gas powered dryers existed. Is that just super old or something?

[–] [email protected] 0 points 2 months ago (1 children)

They work well and just make a lot of sense. However, I think they tend to be more expensive than electric clothes dryers.

[–] [email protected] 0 points 2 months ago (2 children)

They were cheaper back in the day, but they're much more dangerous.

[–] [email protected] 0 points 2 months ago (1 children)
[–] [email protected] 0 points 2 months ago (1 children)

If the vent plugs up you're now having carbon monoxide inside your house, it uses a flame to heat, so more potential for fire. If something goes wrong you can have a gas leak. Electric is install it and forget about it, gas you have to watch it. That being said, I prefer gas, it's more efficient, just have a carbon monoxide detector in the room with the dryer and clean your vents regularly.

[–] [email protected] 1 points 2 months ago

To be fair: Electric dryers are still very much a fire hazard, if they're not properly maintained. But a much smaller one.

[–] [email protected] -1 points 2 months ago

Negative. I bought a new gas dryer ~8 years ago and did plenty of research at the time. Electric dryers are FAR more likely to cause a fire.

[–] [email protected] 0 points 2 months ago

I'm in southern California and I think most houses have gas hookups for driers, often with gas stoves and gas water heaters too.