1
submitted 1 month ago by [email protected] to c/[email protected]
top 16 comments
sorted by: hot top controversial new old
[-] [email protected] 0 points 1 month ago

If you don't know, call someone who does.

[-] [email protected] 1 points 1 month ago

This right here. If you have to ask this question before you trace a pipe back to it's source and figure it out for yourself, you should not be fucking with gas lines.

[-] [email protected] 0 points 1 month ago

That is a gas connection. Screw the flex hose on there and put soapy water on the junction to check for leaks before you open the valve.

[-] [email protected] -1 points 1 month ago

You're not going to see any leak without it being turned on.

[-] [email protected] 1 points 1 month ago* (last edited 1 month ago)

check for leaks before you open the valve

Put the soap on first, then open valve. Are you having a reading comprehension problem or being pedantic?

[-] [email protected] -1 points 1 month ago

Did you read what you wrote or you trying to be an asshole? You literally wrote, check for leaks BEFORE you open the valve.

[-] [email protected] 1 points 1 month ago

You're having a reading comprehension problem.

Put the soap on to check for leaks before turning tap on.

This implies the soap is to check for leaks

[-] [email protected] 0 points 1 month ago

All I said was you need to turn it on to see if it leaks. If you're explaining how to check for a gas leak, It's a pretty important step. By reading his comment, if OP knows nothing about it, which is clear by their asking, they could just put soap on it, see no bubbles, and then turn it on and walk away....

[-] [email protected] 0 points 1 month ago

If op doesn't have the understanding of turning it on to see if it leaks op should hire someone to install their new dryer and return their adult card

[-] [email protected] 1 points 1 month ago

Sure, but no reason to not give all the information, especially when it comes to something as dangerous as a gas leak.

[-] [email protected] 0 points 1 month ago

I did not know gas powered dryers existed. Is that just super old or something?

[-] [email protected] 0 points 1 month ago

They work well and just make a lot of sense. However, I think they tend to be more expensive than electric clothes dryers.

[-] [email protected] 0 points 1 month ago

They were cheaper back in the day, but they're much more dangerous.

[-] [email protected] 0 points 1 month ago
[-] [email protected] 0 points 1 month ago

If the vent plugs up you're now having carbon monoxide inside your house, it uses a flame to heat, so more potential for fire. If something goes wrong you can have a gas leak. Electric is install it and forget about it, gas you have to watch it. That being said, I prefer gas, it's more efficient, just have a carbon monoxide detector in the room with the dryer and clean your vents regularly.

[-] [email protected] 1 points 1 month ago

To be fair: Electric dryers are still very much a fire hazard, if they're not properly maintained. But a much smaller one.

this post was submitted on 15 Aug 2024
1 points (100.0% liked)

Home Improvement

8905 readers
2 users here now

Home Improvement

founded 1 year ago
MODERATORS