Vintage gaming community.
Rules:
If you see these please report them.
Is there something specific to clean?
Sticker residue comes off with Goo Gone from the dollar store. Marker can come off with isopropyl alcohol. Keep both away from the label. Sometimes I'll take the screw out so I can safely clean the plastic while staying away from the internals. A pencil eraser will clean dirty metal contacts.
Outside should be straightforward. I’m hoping to clean down to the PCB. Give every nook and cranky a wipe down.
I guess my main concern would be aging capacitors or other vital pieces of the PCB that may have gotten damaged.
I used to sell video games professionally, and I used distilled white vinegar and a q-tip. Just dip the q-tip in vinegar and wipe the pins, then dry it with the other end. A bunch of black crap will come off - keep doing this until it's clean! To open it, you need I think a 3.5 mm game bit - you can buy them on ebay for a few bucks. You can also buy the batteries with the metal bits already on to solder it back onto the board. Make sure the polarity is correct!! I believe most gameboy games take 2025 batteries but you'll wanna double check, I think a couple take 1212s or 1216s. Hope that helps :)
Just wipe down the contacts with a dry cloth or paper towel if they look dirty. Honestly, besides maybe a battery swap, as long as they're not obviously gross, there shouldn't be anything to worry about.
Nice, I repair electronics semi regularly but nothing older than a few years old. I assumed deterioration could be an issue.
Sounds like it’s just an over thinking on my part. Time to break out the microfiber towel.
Ye, youre overthinking it. Gameboy cartridges are basically 32 contacts to a memory controller (if any) and a rom/ram chip. Nothing more, nothing less