this post was submitted on 05 Feb 2024
3 points (80.0% liked)

Arduino

551 readers
1 users here now

This is an UNOFFICIAL Arduino community.

Everyone who uses Arduino board or their clones or associated boards and/or the Arduino IDE is welcome here. If it involves Arduino hardware or software it's welcome here. If it connects to Arduino hardware it's welcome here. If you're building your own boards that you use with an Arduino it's welcome here. There will be no Arduino elitist bullshit in this community.

You may also be interested in:

AVR

RULES:

  1. It's always a floating input.

  2. All Lemmy.ca rules apply here.

  3. Everyone (see rule 98) is welcome.

  4. If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.

[Did you actually think there were 98 rules?]

  1. If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.

  2. Don’t be a dick. Yes, this is a catch-all rule.

  3. The mod(s) have the final say.

founded 1 year ago
MODERATORS
 

Looking to get into Arduino for the first time. Have already searched about this topic, looking to seek some additional input, as you all seem to know what you are talking about. For reference the Elegoo clone is around half the price of the official pack. There is a Elegoo clone of the Mega board (as opposed to the Uno) which is almost as expensive as the official Uno one. Or would I be better off buying parts individually? I apologise for knowing nothing about electronics.

all 4 comments
sorted by: hot top controversial new old
[–] [email protected] 3 points 9 months ago (1 children)

Since the Arduino boards are open source the clones are generally just as good. The main advantage of buying the official boards is higher quality control, but being able to buy twice as many clones makes up for the occasional dud. You're also helping to support future development of new boards and software.

The kits are the easiest way to get started, only downside is you might end up paying for a few parts you don't use compared to buying individually.

[–] [email protected] 1 points 9 months ago

Thanks for the advice!