this post was submitted on 16 Mar 2024
1560 points (98.0% liked)

memes

10697 readers
2777 users here now

Community rules

1. Be civilNo trolling, bigotry or other insulting / annoying behaviour

2. No politicsThis is non-politics community. For political memes please go to [email protected]

3. No recent repostsCheck for reposts when posting a meme, you can only repost after 1 month

4. No botsNo bots without the express approval of the mods or the admins

5. No Spam/AdsNo advertisements or spam. This is an instance rule and the only way to live.

Sister communities

founded 2 years ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 34 points 9 months ago (2 children)

Using a hole punch to make 5 1/4" disks double sided! Saved a lot of money!

[–] [email protected] 10 points 9 months ago (2 children)

I finally found one I don't understand!

[–] [email protected] 8 points 9 months ago

5 1/4" floppy disk drives had little sensors that would detect a notch in the side of the rectangular disk sleeve (well outside of the round magnetic disk inside). Open notch meant "writeable". Manufacturers would sell "one sided" disks cheaper with missing notch for the backside of the disk to prevent using it. You could use a hole punch to pierce the soft plastic sleeve and make a "writable" hole at the correct spot. The disks inside were identical on both sides, there never was a "one-sided floppy disk", technically. This was during the "C64 and everybody got the games by exchanging floppy disks on the school yard" phase of home computing (ca 1985). Prices for floppy disks mattered a lot back then.

[–] [email protected] 8 points 9 months ago* (last edited 9 months ago) (1 children)

The 5¼" floppy disks consisted of the floppy disk coated in magnetic substrate, encased a plastic envelope. The drive mechanism would only have one read/write head, to read one side of the disk. Disk manufacturers would sell single-sided floppy disks, as well as double-sided floppy disks that you could physically flip over to store more data on the other side. The double-sided floppy disks were a lot more expensive. The only real difference between the two types, though, was that the manufacturers warrantied that the second side would work; to save production costs, the disks were otherwise mostly the same.

The drives had a simple, mechanical write-protect sensor. If the edges of the plastic envelope were intact, putting a disk in the drive would block the sensor, and the drive wouldn't allow writes. But, if there were a small notch cut in the edge, aligned with the sensor, the disk would not trigger the write-protect mode, and you could write to the disk.

The single-sided disks had a notch cut in one edge of the envelope to allow writing to one side of the disk. But, if you cut a notch in the same spot on the opposite side of the envelope, you could disable write-protect mode on the flip side of the disk. A hole punch was the easiest way to make the notch. Voilà! You could store twice as much data on the same disk.

[–] [email protected] 1 points 9 months ago

Damn how didn't I know this obvious trick. But then again when I grew up floppies were on their way out already and dirt cheap anyway.

[–] [email protected] 3 points 9 months ago

I also drilled the 3 1/2'' second corner and it worked. going from 720k to 1.44 Mb