VoronDesign

305 readers

1 users here now

lemmy.world community for VoronDesign 3D printers

founded 1 year ago

MODERATORS

[email protected]

Voron 0.2R1 print dimensions (sopuli.xyz)

submitted 8 months ago by [email protected] to c/[email protected]

10 comments fedilink hide all child comments

How difficult would it be to increase the build plate size of a 0.2R1 from 120 to something larger like 200mm? I would be OK keeping the 120mm Z-axis print height

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 8 months ago (1 children)

Hmm, that's a good point I didn't consider. I didn't think the larger printers were struggling that much maintaining higher chamber temps.

[–] [email protected] 1 points 8 months ago

It's a lot of volume and a lot more area for loses. You're only really heating the chamber with a what a 750 W heater to heat the build plate, by default you're only getting natural convection and radiation to heat the interior, bed fans help and so does something that recirculates the air in the chamber. I generally don't have issues with abs on my 350 mm v2 but larger, less substantial prints will have issues, I'm dropping some extra bed fans in when I do some upgrades this week which should help me get higher temps