3
this post was submitted on 09 Feb 2024
3 points (71.4% liked)
RTLSDR
223 readers
1 users here now
A subreddit for the low-cost software defined radio (SDR) community. While originally dedicated to the [RTL2832U USB rtl-sdr project, relevant content related to general SDR, RF, and similar projects are also welcomed.
Related communities:
- c/embedded
- c/askelectronics
- c/fpga
- c/chipdesign
- c/microcontrollers
- c/dsp
- c/rtlsdr
- c/cprogramming
- c/raspberry_pi
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Those look fine to me, maybe your USB controller is OK? Also might just not be visible. It is more apparent with digital signals like LRPT than APT. I would recommend switching to 2.4MHz sample rate though, nothing in the 137MHz band needs that much bandwidth, and the SNR gain of decimating from 3.2MHz won't make a difference in that band either.
I've not tried using a high samplerate with APT, but here is one with sample drops for a different reason:
They are the little mismatched lines in the middle, they are more obvious when you disable syncing:
It’s a USB3 port and I think the only peripheral on the bus, so I guess I’m lucky. Thanks for the examples. I’ll keep an eye out for those.
As far as your point about the SNR is that because oversampling only reduces read noise, but can’t actually reduce the noise present in the air? (Been a ham for 9 years, but still new to SDR)
The USB3 won't make a difference. It's actually a hardware issue with the rtl2832u in the SDR that causes the drop. I'm not sure why one controller is OK, but that's what I've heard.
I'll be honest that I don't really understand why oversampling helps. But as far as I know it only increases the dynamic range, and if you don't have a large difference between the weakest and strongest signals you are receiving there isn't any benefit. And also, yeah, the environmental noise is probably way higher that the ADC noise.
If you've been a ham for 9 years, you probably know more about this than me. I've been into radio/SDR for about 1.5 years now, and I've mostly just done satellite stuff in that time.