Machinist

674 readers

3 users here now

From Newcomers to Old Timers, a community united by the Industry of Machining

Rules Don't post illegal stuff

Don't post Porn (no sexy aluminum surface finishes don't count)

Don't be an asshat (harassment, bullying etc.)

If you're going to post NSFW stuff, flag it as NSFW, It's ok to post shop Screwups (blood/cuts) just make sure to flag it as NSFW

and Finally make sure to have a good time :D

founded 1 year ago

MODERATORS

[email protected]

Any old timers run a horizontal boring mill? (lemmy.world)

submitted 9 months ago by [email protected] to c/[email protected]

5 comments fedilink hide all child comments

Need some help with overcoming the initial hurdles of a learnjng curve. I'm in a fake it till I make it type situation right now. We acquired most of the equipment that a machine/fab shop would have and most of them, there is plenty of information online to learn from. Except for the horizontal boring mill, and I am struggling. The tooling all needs to be made up for it. Nothing I can purchase direct. The spindle is a MT6. My supplier can only get me reducers to MT5. And setting up parts is quite time consuming.

Any advice or know how on being able to turn a profit on this machine would be appreciated.

The machine is a TOS W100 in mostly good working order. Apart from the boring head dropping 0.020" if I cut in reverse travel after forward travel cutting.

Thanks

you are viewing a single comment's thread
view the rest of the comments

[+] [email protected] 1 points 9 months ago* (last edited 9 months ago) (1 children)

[removed by mod]

[–] [email protected] 2 points 9 months ago (1 children)

Yeah i crashed it like 3 times already. Does that make me a seasoned veteran? Lucky me it cones with a cutout clutch that has saved , the work, machine and my pants.

Right now It's less so questions as more of I don't know what I don't know.

Tool angles and geometry Is one, is carbide viable for one of these or should I be using high speed steel for boring?

For speeds and feeds do you use the general rules as you would for turning or milling or something else?

Work holding fixtures any recommendations on what is essential to have at the ready? Most used ?