Probably not that much different, just getting 1/4 blanks, ripping on the tablesaw then use the router table to get them flush. Used to use a hand plane for that but any excuse to buy a power tool! I like to use the fancy 3 string bridges, not too bad if you buy multiples on A. But my 1st used threaded rod and nuts for the nut and a floating bridge. I was way too confident going into that one though... didn't measure things correctly so it has a weird scale length, my scarf jointed angled headstock didn't quite work out the way I wanted it to, and I made the neck out of a single piece of poplar, obviously with no fretboard, lamination or truss rod it's a banana now, but I still have it, if nothing else to remember where I started and it's a measuring stick on how far I've come.