9
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 02 Jan 2024
9 points (100.0% liked)
SolarDIY
423 readers
1 users here now
SolarDIY is a vibrant community dedicated to embracing the power of solar energy. Here, we encourage you to showcase your ingenious ideas, innovative projects, and inspiring stories, while also seeking valuable advice, fresh ideas, and fostering meaningful connections.
Our passion lies in witnessing the remarkable achievements of individuals who have harnessed the potential of solar energy. Whether you have successfully wired your entire house with solar panels, created a portable solar-powered generator, or crafted an efficient solar pool heater, we are eager to learn from your experiences and celebrate your accomplishments.
Join us on this empowering journey as we explore the endless possibilities of solar energy and inspire one another to make a positive impact on our environment and our lives. Together, we can unlock the full potential of solar power and shape a sustainable future.
Share your DIY solar projects, exchange knowledge, and let your creativity shine!
founded 1 year ago
MODERATORS
Nominal 12v panel + nominal 12v battery is good, and the Wanderer will charge LiFePO4 with a canned profile IIRC.
Here's the next hurdle: I'd expect a 10w panel on PWM to max at ~7w under excellent conditions; we could estimate this more accurately better if we knew the panel specs. And the controller will require a certain amount of power to run its own innards. The Wanderer 10A specs say
Self-consumption <10mAbut this may be with the panel[s] disconnected, or when the panels are connected but there is no PV input. Or it may really be <10mA in all cases; not much electronics inside a PWM compared to MPPT. If you do it please report back with what you find.These kinds of challenges are common in very small (experimental, learning) solar setups; when the numbers get larger this kind of challenge largely gets lost in the noise of bigger numbers.
Thank you, this is really useful information. I found the panel specs:
We can ballpark maximal/theoretical harvest by multiplying the bank voltage (Vbatt) by the panel's short circuit current (Isc).
Real world conditions and esoteric concepts like I/V curve fill factor will conspire to depress observed current (A) and therefore observed harvest (W). The quick math to above is just to illustrate how the bank voltage tail wags the PWM dog.
Keep us in the loop about how the project turns out. :-)