This is an UNOFFICIAL Arduino community.
Everyone who uses Arduino board or their clones or associated boards and/or the Arduino IDE is welcome here. If it involves Arduino hardware or software it's welcome here. If it connects to Arduino hardware it's welcome here. If you're building your own boards that you use with an Arduino it's welcome here. There will be no Arduino elitist bullshit in this community.
You may also be interested in:
RULES:
It's always a floating input.
All Lemmy.ca rules apply here.
Everyone (see rule 98) is welcome.
If you’ve seen a question 100 times answer it the 101st time or ignore it. Even better, write a complete, detailed answer and suggest that the mod(s) pin it to the community.
[Did you actually think there were 98 rules?]
If you present something as fact and are asked to provide proof or a source provide proof or a source. Proof must be from a reliable source. If you fail to provide proof or a source your post or comment may be removed.
Don’t be a dick. Yes, this is a catch-all rule.
The mod(s) have the final say.
I give you Frankenduino. It's an Arduino ProMini soldered onto a piece of protoboard and wired up to the Nano pinout.
I have 10 Nanos on order but I really needed to keep the project moving.
This ProMini has an ATMEGAS168 chip on it but that's good enough for what I'm doing.
Why is this wire damaged? Too many drinks when soldering or not enough?
I forgot a couple of wires and had to add them after the fact. I got a bit close to that one with my soldering iron. The insulation is melted right down to the wire but it's outboard and only used for development so I hope Lemmy QA will give me a pass.
the “any landing you walk away from is a good landing” defense?
Yup. That's my story and I'm sticking to it.