1306
Off by one solitude
(fed.dyne.org)
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
this post was submitted on 19 Sep 2024
1306 points (98.5% liked)
Programmer Humor
32060 readers
1130 users here now
Post funny things about programming here! (Or just rant about your favourite programming language.)
Rules:
- Posts must be relevant to programming, programmers, or computer science.
- No NSFW content.
- Jokes must be in good taste. No hate speech, bigotry, etc.
founded 5 years ago
MODERATORS
I've seen a lot of rulers that actually don't have a mark at 0 and instead go right to the edge as 0. Typically they are worn down, being made of wood, so the accuracy of the first inch is dubious. To ensure the distance is correct, sliding the ruler down one unit is a good idea. So, my ruler starts at 0 but my measurements start at 1.
That's why decent rulers have a 0 and a margin:
It really depends on what you're measuring. Good luck measuring the distance from a corner if you can't get 0 to touch the end.
Tape measures are almost always designed with this in mind, so you can hook the end over an edge, or butt it up against something and the measurement will be accurate both ways, since the metal end can slide in or out by just the right amount.
OMG! I genuinely thought all the tape measures I have handled were a little broken.
Just shave down the rulers margin!