this post was submitted on 31 Mar 2024
79 points (94.4% liked)
Offbeat
1265 readers
41 users here now
The world is a weird place filled with even weirder news.
Post your funny, weird, strange, or quirky news stories here!
Lemmy.ca Rules
- No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia.
- Be respectful. Everyone should feel welcome here.
- No porn.
- No Ads / Spamming.
Community Rules
- No editorialized titles
- No satire news sites (The Beaverton, The Onion, etc...)
- No politics
- Submissions must be no older than 2 months (i.e. the article should be "recent" news)
Similar Communities
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Now I'd like to know how a saw blade could actually run away like that?
I can imagine a lose saw blade rolling down a hill, but it probably won't gain that much speed. And within a saw, it is mounted on an axis and surrounded by a lot of other stuff, so even if the nut comes lose on the axis, it won't be going anywhere much, at least not while taking that much rotational energy.
The blade got spun up, then came off the saw, likely because the retaining nut came off. The blades aren't on some long mandrel, they're on a short bump of a shaft that the nut screws down to. Take a look at how discs connect to angle grinders and you'll have a good idea of how concrete saws do it
It is perplexing, because those usually have a guard over them aswell. Maybe the shaft stud snapped right at the blade, and machine had the blade without guard rotated down over it?