This corner of the shower seems to be having some mold issues from regular use. Water seems to be collecting in that spot after a shower and doesn't seem to be draining properly. Is there anything I can do for a permanent fix?
I've tried keeping my bath fan on for an hour after the shower and don't want to have to squeegy it after each use.
Crappy solutions would be to occasionally murder the mold or to build up something waterproof in the corner so the water rolls off. Unfortunately there is really only one fix, which is to re-tile that section (possibly the entire bottom) so it slopes properly to the drain.
Thanks for the reply. I'm afraid that murdering the mold is something I have to sign up for now given my present situation.
I was considering adding something waterproof in the corner so the water rolls off like you said, but I am not sure what the best way to do that was and whether or not it could look like a clean fix. I would still like to explore what that fix might look like which would help me understand why it is a crappy solution. What are your thoughts here?
It would be something like adding a corner of slanted tile there and grouting it into place. There is no way it will ever look like it was supposed to be there. And if you don't get it sealed 100%, now you have a void which is basically permanently wet inside.
Another option would be to build up some silicone in the area, that is probably going to look even less good, but it will be easier, more likely to seal well, and can be removed. Do note if the tile is bumpy, getting the silicone out of the bumps later might prove difficult, but if the tile is smooth, you can scrape it off pretty easily. After you put it down, you can smooth the silicone out with a wetted finger or smoothing tool.
I would personally be tempted to go the silicone route if a full fix is off the table since mold is evil.
Ah yeah I've used silicone to recaulk the glass when the mold got under it. I might take your suggestion here... I'll end up using a lot just to get the slope. As far as shaping it, I suppose I can use a straightedge to form the slope. Luckily the surface is flat so removing the silicone won't be a problem