Skateboarding

I am new to skating and would like to try to get more into driving around town, however, it doesn't feel safe yet doing it on my standard Bones 103A 52 mm wheels. Our general old European city has some rough terrain (wildly switching between asphalt, stone, small patches of cobblestone, you get the idea).

So I thought I'd try out softer cruiser wheels like the Bones Rough Riders (80A hardness, 56 or 59 mm diameter) for driving around town without breaking my wrist over a small stone again. I'd still like to keep the harder wheels for the skate parks, though, and carrying around two boards seems like a huge hassle.

So what do you think about getting the Rough Riders with a separate set of bearings so I can do a quick wheel change whenever I need to? Is this dumb for any kind of reason I can't think of? Should I go with 56 or 59 mm when I don't want to install riser pads (if even possible)? Do you have any other wheel suggestions for this application?

Found at Brodega skateboards (Denmark)

I'm not affiliated, just found it funny.

A local skatepark held an official opening inviting Rune Glifberg and Nicky Guerrero to do a demo. The weather was tricky, but in between rain they managed to pull off a few tricks in the deep end. I didn't get a good photo of Rune.

(The 100kb limit on pictures is horrible.)

Full recap of the four day skateboarding event CPH Open 2023 by Flatspot Magazine.

My Formula 4s got flat spots, sounding like a moped when I ride the bowl. I'm looking for larger sizes from 56mm upwards. I need mostly for very smooth surfaces and high speed, but sometimes also rougher concrete. I don't have a need for ultra soft wheels.