this post was submitted on 02 Jan 2025
1 points (100.0% liked)

Welcome to R/3D Printing! Come for the Benchy, stay for the Calibration!

6 readers
1 users here now

/r/3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed...

founded 2 years ago
MODERATORS
[email protected]
1
Dehumidifying in an a wine refrigerator (zerobytes.monster)
submitted 1 week ago by [email protected] to c/[email protected]
0 comments fedilink hide all child comments
 
The original post: /r/3dprinting by /u/rangawal on 2025-01-02 09:40:27.

I bought a large wine fridge (200cm x 60cm x 60cm) for filament storage. It's very new with a faulty compressor, so not turned on, but I expect it's airtight. I bought a small electric dehumidifier and have been running it on the bottom shelf 24/7 for the past few days, and about 100ml of water is in the tank. However, the humidity still sits at around 50% - no improvement since adding the dehumidifier. Is there something I'm not understanding? Is there a better way of bringing down the humidity?

no comments (yet)
sorted by: hot top controversial new old
there doesn't seem to be anything here