this post was submitted on 03 Aug 2023
1156 points (97.7% liked)

Memes

45688 readers
854 users here now

Rules:

  1. Be civil and nice.
  2. Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.

founded 5 years ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 17 points 1 year ago (10 children)

My robot mower does this. It traverses the lawn like a Roomba. Took me awhile to get used to.

[–] [email protected] 6 points 1 year ago (6 children)
[–] [email protected] 12 points 1 year ago (1 children)

My guy, robot mowers have been around for some time now. The catch is you need to bury a guide wire around the perimeter of the area the mower is meant to cut. Or at least that was the case the last time I looked into getting one.

[–] [email protected] 3 points 1 year ago (1 children)

There are some which are guided via gps now. However, i won't trust them being so precise. For me/us burying a guide wire was the better solution. Some manufacturers even claim, that you dont have to burry the line cos it will be overgrown by grass after a short amount of time.

[–] [email protected] 3 points 1 year ago (2 children)

GPS will only ever be accurate within 5 meters, which won’t cut it for small yards where even 1 meter over the line may send it down a hill or into the neighbors yard

[–] [email protected] 2 points 1 year ago

Linus Tech Tips reviewed one that came with a little radio tower it used for position (guessing it used a combination of many sensors). Seemed to work OK in his flat little backyard.

[–] [email protected] 1 points 1 year ago

GPS gets down to 1cm or finer precision with an additional, stationary receiver, and time corrections. https://learn.sparkfun.com/tutorials/how-to-build-a-diy-gnss-reference-station

People have built DIY mowers utilizing tech like this. Problem is, the RTK receivers are far too expensive for all but the higher end mowers.

load more comments (4 replies)
load more comments (7 replies)