this post was submitted on 19 Jun 2024
314 points (85.7% liked)

Programmer Humor

19589 readers
600 users here now

Welcome to Programmer Humor!

This is a place where you can post jokes, memes, humor, etc. related to programming!

For sharing awful code theres also Programming Horror.

Rules

founded 1 year ago
MODERATORS
 

Today in our newest take on "older technology is better": why NAT rules!

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 27 points 5 months ago* (last edited 5 months ago) (36 children)

Yes, but why would you want to? We have enough addresses for the foreseeable future.

[–] [email protected] 15 points 5 months ago* (last edited 5 months ago) (17 children)

1:1 stateless NAT is useful for static IPs. Since all your addresses are otherwise global, if you need to switch providers or give up your /64, then you'll need to re-address your static addresses. Instead, you can give your machines static private IPs, and just translate the prefix when going through NAT. It's a lot less horrible than IPv4 NAT since there's no connection tracking needed.

This is something I probably should have done setting up my home Kubernetes cluster. My current IPv6 prefix is from Hurricane Electric, and if my ISP ever gives me a real IPv6 prefix, I will have to delete the entire cluster and recreate it with the new prefix.

[–] [email protected] 7 points 5 months ago (16 children)

It should only be needed if your ISP is brain-dead and only gives you a /64 instead of what they should be doing and also giving you a /56 or /48 with prefix delegation (I.e it should be getting both a 64 for the wan interface, and a delegation for routing)

You router should be using that prefix and sticking just a /64 on the lan interface which it advertises appropriately (and you can route the others as you please)

Internal ipv6 should be using site-local ipv6, and if they have internet access they would have both addresses.

[–] [email protected] 2 points 5 months ago* (last edited 5 months ago) (1 children)

64 for the wan interface

Nitpicking, but the address for the wan interface wouldn't have a prefix, so the host would just set it as a /128 (point-to-point)

[–] [email protected] 1 points 5 months ago

Ehh, I've seen both. Perhaps not in a home router context though, never really bothered to check

load more comments (14 replies)
load more comments (14 replies)
load more comments (32 replies)