this post was submitted on 13 Jun 2023
0 points (NaN% liked)

flashlight

2942 readers
85 users here now

Portable illumination

Rules:

  1. Be excellent to each other
  2. Don't be the reason we need to make more rules

Related:

founded 1 year ago
MODERATORS
[email protected]
[email protected]
0
Triple trouble - emitters not equally bright (lemmy.world)
submitted 1 year ago by [email protected] to c/[email protected]
3 comments fedilink hide all child comments
 

Hi All,

I recently built my first 2x S2+ triples with KD SST20 MCPCBs and Convoy 5A drivers. On one of them I noticed, when at 1%, 1 emitter is noticeably dimmer than the other 2. My second triple I changed the sense resistor to provide slightly more amps and that one is fine.

Anyone experienced this? Could it be a bad mcpcb, driver/level issue?

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 0 points 1 year ago (2 children)

It could be a bad reflow, but it's common for one to be brighter at moonlight because of forward voltage tolerances

[–] [email protected] 0 points 1 year ago (1 children)

common for one to be brighter at moonlight because of forward voltage tolerances

Interesting, I would never have guessed. Glad my TS10 doesn't show that even at level 1 brightness.

[–] [email protected] 1 points 1 year ago* (last edited 1 year ago)

Experience like this is why this community rocks. Intrigued by Adair21’s answer, I read around the web to understand better - I didn’t realise there could be so much tolerance in LED forward voltages!

As a result, when in parallel/at the same drive voltage, different currents drawn = different relative brightness. Outside of independent resistors, you’d need to get lucky with matched emitter tolerances or just run above moonlight so that the difference is less noticeable.

Maybe it’s a reflection of the cost of the KD boards?