75
submitted 23 hours ago by [email protected] to c/[email protected]
top 17 comments
sorted by: hot top controversial new old
[-] [email protected] 4 points 5 hours ago* (last edited 5 hours ago)

There are adapters that allow you to plug an M-key SSD into that A+E-key slot, for example that one: https://www.delock.de/produkt/64137/merkmale.html?f=s

They should work on most computers, but some machines have a whitelist of supported WiFi cards and ignore anything else you plug into the slot for the WiFi module.

[-] [email protected] 49 points 23 hours ago* (last edited 23 hours ago)

Looks like one to me. Remember that M.2 is a form factor. You can have an M.2 slot that does not support SSD storage for example. I have one that is only intended to work with wifi adapters.

Based on the wifi designation on the board I'll bet it only works with wifi cards.

M.2 is a form-factor. It talks about the shape only, it says nothing about what the device you are using can do. Many boards have restrictions on supported devices for the physical slot.

[-] [email protected] 9 points 23 hours ago

Oh thanks, I didn’t know that. I thought it was an all purpose PCIe connector. Is there any way to find out whether it supports SSD storage? Is that way the dmidecode from my other comment (and basically saying that it doesn’t support storage?)

[-] [email protected] 5 points 17 hours ago* (last edited 17 hours ago)

Scroll down a bit in this article. There's a list of what each of the available keys are required to provide. A "key" in this context is basically a notch in a certain location, which then defines the meaning of the various pins of the connector. Some devices have multiple keys, as some of the specifications have a common subset. Like key A+E is common, because E provides almost everything that A does, so a device that only requires the common interfaces can work in both. Cars that rely on one of the exclusive interfaces will have the specific key of course. This A+E communication is often used for WiFi cards.

Sockets always only have one key though, for obvious reasons.

Edit: correction/clarification

[-] [email protected] 12 points 22 hours ago

The most reliable way I know is to seek documentation for the board. It's up there with PCI lanes in that the board designer will know what has been configured to work with that physical connector. This kind of info is definitely part of your motherboard documentation.

I'm not familiar with dmidecode so unfortunately I cannot comment on that.

[-] [email protected] 2 points 22 hours ago* (last edited 22 hours ago)

Is there any way to find out whether it supports SSD storage?

Have a look at the notch in the slot. SSDs will have either M key, B+M key, or very rarely just B key.

WiFi modules are A, E, or A+E

[-] [email protected] 5 points 22 hours ago

But this one looks like SATA

[-] [email protected] 1 points 14 hours ago* (last edited 14 hours ago)

Yeah I think this an mSATA port.

Edit: on second glance I think the right part of the connector has too many pins.

[-] [email protected] 14 points 19 hours ago* (last edited 19 hours ago)

SATJA slot

IℲIM slot

[-] [email protected] 23 points 21 hours ago* (last edited 21 hours ago)

It's literally got WIFI printed on the board below it, likely a slot for a wifi card.

[-] [email protected] 15 points 18 hours ago

.....a wifi card that uses a certain type of M.2 connector

[-] [email protected] 1 points 10 hours ago
[-] [email protected] 7 points 18 hours ago

Sure, but there are several and op didn't specify what they wanted to do with it, typically if someone uses the m2.22xx naming they expect to put storage in it, which would not work here. So I was just trying to make that especially clear.

[-] [email protected] 27 points 23 hours ago* (last edited 23 hours ago)

It's is M.2, but not the M/B+M key most M2 SSDs use but rather a A+E meant for WIFI/Bluetooth. According to this video it's essentially 2 PCI Express x1 lanes and USB 2.0. The video goes on to explain some possible alternative uses:

  • A gigabit ethernet adapter
  • 2x SATA ports for a standard SATA drive
  • Coral tensor processor
  • SD card reader
  • 2x USB A-type ports
  • Some type of SIM card adapter (video wasn't quite sure on it either)
  • A PCI Express x16 slot that only functionally works as a x1

So while does this slot has it's uses, it's not meant to be used for M.2 drives but rather WIFI.

[-] [email protected] 2 points 15 hours ago

it's essentially 2 PCI Express x1 lanes and USB 2.0

Sometimes there's only a single PCIe lane though. And as you say, that's not a x2 but explicitly two x1s.

No WiFi card needs the bandwidth (yet), at PCIe 3 speeds you've got around 7.8Gbps for a x1, and PCIe 4 double that.

The Coral comes in a "dual" version for exactly this reason (https://coral.ai/products/m2-accelerator-dual-edgetpu/) you just have to be very sure the slot you're putting it in is actually delivering two PCIe connections.

Also for bonus fun, most WiFi/BT cards use the PCIe interface for the WiFi and USB for the Bluetooth.

[-] [email protected] 4 points 23 hours ago

It looks like it is one, but dmidecode doesn't show it.

# sudo dmidecode --type slot           
# dmidecode 3.4
Getting SMBIOS data from sysfs.
SMBIOS 3.0.0 present.

Handle 0x001C, DMI type 9, 17 bytes
System Slot Information
        Designation: J6B2
        Type: x16 PCI Express
        Current Usage: Available
        Length: Long
        ID: 1
        Characteristics:
                3.3 V is provided
                Opening is shared
                PME signal is supported
        Bus Address: 0000:ff:10.0

Handle 0x001D, DMI type 9, 17 bytes
System Slot Information
        Designation: J6B1
        Type: x1 PCI Express
        Current Usage: Available
        Length: Short
        ID: 2
        Characteristics:
                3.3 V is provided
                Opening is shared
                PME signal is supported
        Bus Address: 0000:ff:1c.4

Handle 0x001E, DMI type 9, 17 bytes
System Slot Information
        Designation: J6D1
        Type: x4 PCI Express
        Current Usage: Available
        Length: Long
        ID: 3
        Characteristics:
                3.3 V is provided
                Opening is shared
                PME signal is supported
        Bus Address: 0000:ff:1d.0

Handle 0x001F, DMI type 9, 17 bytes
System Slot Information
        Designation: J7B1
        Type: x1 PCI Express
        Current Usage: Available
        Length: Short
        ID: 4
        Characteristics:
                3.3 V is provided
                Opening is shared
                PME signal is supported
        Bus Address: 0000:ff:1c.5


Wrong DMI structures length: 3135 bytes announced, structures occupy 3136 bytes.
[-] [email protected] 0 points 23 hours ago

M.2 SATA slot, but no PCIe.

https://en.wikipedia.org/wiki/M.2

You got a manual for that board?

this post was submitted on 26 Sep 2024
75 points (95.2% liked)

Ask Lemmy

26332 readers
1439 users here now

A Fediverse community for open-ended, thought provoking questions


Rules: (interactive)


1) Be nice and; have funDoxxing, trolling, sealioning, racism, and toxicity are not welcomed in AskLemmy. Remember what your mother said: if you can't say something nice, don't say anything at all. In addition, the site-wide Lemmy.world terms of service also apply here. Please familiarize yourself with them


2) All posts must end with a '?'This is sort of like Jeopardy. Please phrase all post titles in the form of a proper question ending with ?


3) No spamPlease do not flood the community with nonsense. Actual suspected spammers will be banned on site. No astroturfing.


4) NSFW is okay, within reasonJust remember to tag posts with either a content warning or a [NSFW] tag. Overtly sexual posts are not allowed, please direct them to either [email protected] or [email protected]. NSFW comments should be restricted to posts tagged [NSFW].


5) This is not a support community.
It is not a place for 'how do I?', type questions. If you have any questions regarding the site itself or would like to report a community, please direct them to Lemmy.world Support or email [email protected]. For other questions check our partnered communities list, or use the search function.


Reminder: The terms of service apply here too.

Partnered Communities:

Tech Support

No Stupid Questions

You Should Know

Reddit

Jokes

Ask Ouija


Logo design credit goes to: tubbadu


founded 1 year ago
MODERATORS